White Line Natura Azulene

• Capacity: 100, 250, 500, 1000 g
• Melting point: + 40-42 ° С
• Application area: face, armpits, bikini
• Application Method: Spatula
• Removal method: without strip
• Quantity in box:
• 100g pack: 30 pcs
• 250 g box: 16 pieces
• can of 500 g: 9 pieces
• 500g pack: 20 pcs
• 1000g pack: 10 pcs

They operate at + 42 ° С, which excludes the possibility of a burn.

Wax is applied with a thin layer of spatula, without regard to the direction of hair growth.

Clearly repeat the contours of the body, because they are distinguished by high plasticity, allowing them to finish difficult-to-reach areas the first time.

Due to the long-term heat exposure (5–12 seconds), the waxes steam the skin well, seize every, even short and hard hair, and only then freeze.

Wax is removed with a film, completely removing all the hairs with roots, do not leave behind broken hair, irritation and redness on the skin.

Economical to use, hair can be removed from the armpit with a single appliqué. Reduce the expenditure of funds by about 30%.

ITALWAX Film Wax Use Rules:

1. Heat the wax in an electric heater to t + 42 ° C.
2. Treat the depilation zone with alcohol-containing lotion.
3. Apply a small amount of talc.
4. Apply a thin layer of wax with a spatula, regardless of the direction of hair growth, but towards you, leaving a small “petal” for which you can then grab onto it (we try to depile the armpit with a single application).

   ATTENTION! Apply slowly, carefully press the spatula, applying the necessary effort.

5. The wax will harden after 5-6 seconds (the wax ready to be removed should not stick to the hand when touched).
6. Pre-pulling the skin in the direction opposite to the separation, a sharp movement to remove the wax in a direction away from you parallel to the skin. Repeat the procedure in the next section.
7. After depilation, treat the skin with a soothing, cooling, oil-free means: cooling cream / gel, White Orchid emulsion lotion.

The main mistakes when using film wax:

The wax stretches like caramel and is badly removed.

Cause: the wax did not have time to harden.

Decision: dry the wax with talcum powder, wait 2-3 seconds and remove.

After waxing, hair remains.

Cause: spatula with wax is not pressed to the skin enough, so the hairs do not fall into the layer of wax.

Decision: Apply wax to the skin with the remaining hairs, pressing the spatula closer to the depilation zone.

After removal, the wax on the edges of the application remains on the skin.

Cause: uneven waxing.

Decision: form an appliqué with the same layer in the middle and along the edges.